Phone
: (786) 2651960 - www.stetsom.com - export@stetsom.com
NOT TURN ON:
- The cables are not correctly connected (terminals BAT, GND and REM). Make sure that all
connections has mechanical and electrical contact.
- Fuses/circuit breakers (external) are defective or burned. Take care about the correct value of
the new fuse!
- Output remote/electric antenna of CD-player/MP3-player with problem (burn).
NO SOUND:
- The cables of speakers or plugs RCA are not connected correctly.
- Check if the LEVEL control is not in the minimum.
NO SOUND / RED LED (PROTECTION) ILLUMINATED:
- Speakers or cables (damaged), so, check speakers, cables and connections.
- Check the battery charge.
BAD SOUND QUALITY (DISTORTION):
- The speakers are overloaded, so, decrease the level and redo the gain adjustment (see iten
2/general description).
WEAK BASS:
- Cables of speakers (+) and (-) are changed, speakers out of phase (see iten 5/general
description).
MOTOR NOISE, HORN, SIGNAL LIGHT, ETC:
- Use suppressive cables in ignition candles.
- Use capacitors in the alternator, horn, ignition.
- Pass the shielded RCA cable away from any other cable, because it is more sensitive to
interference.
- Connect to power (+12V) separate for the sound system. Use a fuse to 30 cm from the battery
for protection.
- Make a good grounding of the amplifier. To do this, remove the paint from the chassis of the
vehicle at the desired point. Screw the cable using a ground terminal. To protect from
oxidation, insulate with paint.
- Do not loop the ground wire. Avoid using several ground wires. Prefer a star connection, with all
the ground wires aside from a single point.
HOW TO ACT IN CASE OF PROBLEMS
V 400.4
V 600.4
V 400.4
V 600.4
Out/2011 R1
VENOM LINE
VENOM LINE
F U L L
BRIDGE
F U L L
BRIDGE
USER’S GUIDE
MODEL:
V 400.4
Channels:
4
Power @ 13.8V Stereo 2 Ohms:
4 x 103 Watts RMS
Power @ 13.8V Stereo 4 Ohms:
4 x 60 Watts RMS
Power @ 13.8V Bridge 4 Ohms:
2 x 206 Watts RMS
Minimum Output Impedance:
2 Ohm
Minimum Input Sensitivity:
0,2V
Total Harmonic Distortion:
< 0,9 % THD
Signal to Noise:
> 90 dB
Crossover HIGH PASS:
90 Hz
Crossover LOW PASS:
90 Hz
Frequency Response (-3dB) @ 2 Ohms:
20 Hz to 22 KHz
Power Tension:
9 to 15V
Consumption Sinal Musical (12,6 V):
19A
Consumption Sinal BASS (12,6 V):
38A
Dimensions (A x L x C):
40x240x207 mm
Weight:
1,5 Kg
V 600.4
4
4x150 Watts RMS
4x120 Watts RMS
2x300 Watts RMS
2 Ohm
0,2V
< 0,9 % THD
> 90 dB
70Hz to 700Hz
40 Hz to 700Hz
20 Hz to 22 KHz
9 to 15V
40A
70A
40x240x230 mm
1,8 Kg
SPECIFICATIONS
