7.
Fit the wing tip sub assemblies WT to spar and R4. Check for a positive fit at each wing tip, leading edge jig,
and trailing edge jig joint. Tack glue assembly together at each tab and notch joint along the leading edge,
trailing edge, and wing tip.
8.
Key the leading edge cap strip LE3 into position. Tack glue at each tab and notch joint then run a small amount
of thin cal along the leading edge jig to cap strip joints.
Complete the leading edge by laminating the 3/32” balsa center section leading edge doubler strips, LE4, to the top and
bottom of the center section leading edge jig.
© 2003 Stevens AeroModel.
Page 14 of 20
