© 2007 Stevens AeroModel.
Page 3 of 35
REQUIRED TO COMPLETE KIT:
Kit Contents
:
Computer drawn Plan Set
Illustrated Instruction Manual
Laser Cut Parts Inventory (on next page)
2 - .045” x 24” length music wire
2 - .045” x 12” length music wire
1 - 1/16” x 12” length music wire
2 - .09” OD x 18” length push-rod housing
2 - 1/4” square x 24” length balsa leading edge
1 - Pre formed wire landing gear (1/8” diameter music wire)
Hardware
Bag
•
2 – Pkg. DuBro RC Razor Control Horns [4] (DUB936)
•
1 – Pkg. DuBro RC Micro II EZ-Link [4] (DUB920/27805)
•
2 – Pkg. DuBro RC Micro E/Z Connector [4] (DUB845)
•
1 – Pair 3.0” Foam Wheel [2]
•
2 – 1/8” Wheel Retention Star Washers
•
6 – 4-40 Blind Nut
•
2 – 4-40 x 1/2” Bolt
•
4 – 4-40 x 3/8” Bolt
•
1 – Package Gum Rubber Bands #33 [10]
•
2 – 3/16” Neo. Magnet
•
1 – 1/4” Dia. x 4-3/4” Length Hardwood Dowel
•
2 – 3/16” x 4-3/4” Length Hardwood Dowel
•
1 – Laser Cut Basswood Elevator Joiner
Recommended Finishing Items
:
1.
2 Rolls of AeroFILM Lite (Solarfilm Solite, or Nelson Lite Film may be substituted).
Suggested Electronics:
1.
4 - Micro Servos (Hitec HS-81) (Requires 2 Additional HS-65 Servos for Flaps Option)
2.
1 - 6” Y-Servo Extension
3.
2 - 6” Servo Extension
4.
1 - Receiver 4-6 Ch.
Power System:
1.
Hacker A30-16M Direct Drive or VSport 350 (VS301316)
2.
11x5.5 – 11x7 APC-E Propeller
3.
11.1v 2200mAh LiPo (Rated for 20C discharge).
4.
Castle Creations Thunderbird 36 or Phoenix 35 ESC
Items You May Need:
1.
Thin CA (super glue)
2.
Medium CA (super glue)
3. Razor
Blade(s)
4.
Fine Grit Sand Paper and Sanding Block
5. Clear
Tape
6.
Balsa Wood Filler
