2
The standard unit is equipped with an eight (8) foot power cord that requires a 115 Volt, 60 Cycle, 1 Phase
properly grounded
electrical receptacle. The power cord comes with a 3 prong plug for grounding pur-
poses. Any attempt to cut off the grounding spike or to connect to an ungrounded adapter plug will void the
warranty, terminate the manufacturers responsibility and could result in serious injury.
The circuit must be protected with a 15 or 20 ampere fuse or breaker. The unit must be isolated on a circuit
and not plugged into an extension cord.
OPERATION
Initial Start Up
After satisfying the installation requirements, the unit is ready to start. The unit will start when the power
cord is connected to the required power source. If the compressor does not start when the unit is initially
plugged in, check to make sure that the temperature control is not in the "off " position. Allow the unit to run
a minimum of two hours before loading it with product. When loading the unit with product, take care not to
block the air flow at the back of the cabinet as this would affect the performance of the cabinet.
Temperature Control
The Temperature Control is located on the back wall of the cabinet liner and is factory set to maintain an
average cabinet temperature of 35 to 40 Deg. F. To obtain colder temperatures turn the Temperature
Control knob clockwise and visa versa. Allow the unit a minimum of one hour to respond to a control setting
adjustment.
Defrost
Your Silver King unit is an automatic defrost unit. No additional plumbing is required. The frost buildup on
the evaporator coil will clear each time the compressor shuts off and the condensate will drain to the
condensate evaporator pan where it will evaporate. It is important that the unit be level so the condensate
can drain properly.
MAINTENANCE
Preventative maintenance is minimal although these few steps are very important to continued operation
and maximizing the life of the appliance.
Cabinet Surfaces
The cabinet interior and exterior are stainless steel. These surfaces should be cleaned periodically with a
solution of warm water and mild soap and wiped dry with a soft cloth. Should a surface become stained, do
not attempt to clean with an abrasive cleaner or scouring pad. Use a soft cleanser and rub with the grain of
the metal to avoid scratching the surface.
Condenser
Periodically, dust on the condenser coil must be cleaned off. The condenser is located on the left side of
the front bottom grill. To clean it, remove the front bottom grill (2 screws) and simply vacuum the exposed
condenser coil or brush it to clear the accumulated debris. This will need to be done regularly to maintain
the compressor warranty!
90028
MODEL___________________ SERIAL NO.______________________ DATE INSTALLED_____________________
