10
Stewart Filmscreen
ADJUSTING THE SCREEN EXTENSION
i
i
CAUTION
Improper adjustment of the limits can cause irreparable damage to the screen itself, resulting in
voiding the factory warranty
The extension and retraction limits have been preset at the factory In general, we advise you to avoid
readjusting these limits
In some cases, to enable proper alignment of the displayed image on the screen, you may need to
adjust the extension of the screen If adjustment to the extension is necessary, carefully follow these
instructions
WARNING!
The screen is fully retracted when the batten is flush with the bottom of the case Do not attempt
adjustments with the blue retraction (UP) thumbwheel that will further retract the screen Incorrect
adjustment of the thumbwheel will cause severe screen damage Please consult the factory if you
have any questions
MODIFYING THE EXTENSION OF THE SCREEN
You can increase the extension of the screen up to 3” (7 6 cm) past the factory preset stop, or you can
decrease the extension by approximately 4-6” (10-15 cm) from the factory preset stop Do not attempt
to modify the screen extension beyond these recommended amounts
The thumbwheels are located on the left side of the screen roller tube inside the case, as shown in Figure
3 Remove the cover of the case using a hex head screwdriver When finished, replace the cover
