Stewart Golf Q Series, Owner'S Manual

10

11

HANDSET GUIDE

Your Q Follow is supplied with a rechargeable Bluetooth handset. The handset is 

supplied paired to your machine and cannot be used with any other.

1.  Forward/speed up.
2.  Indicator light.
3.  Left & right turn.
4.  STOP. Use as primary stopping function.
5.  Slow down/reverse.
6.  Glide Stop. Also see notes on glide steering. 
7.  Cruise Control speeds.
8.  Follow.
9.  Bluetooth ON/OFF. Press & hold for one second to turn on. When turning off, a red 

light shows momentarily.

In normal use, the indicator light will be blue:

LIGHT OFF: 

Handset is switched off.

LIGHT FLASHING: 

Handset is on, but not connected to the machine.

LIGHT ON:

 Handset is on and connection has been established.

WARNING

NEVER

 open the handset 

unless you have been 

instructed to do so by our 

support team. Always ensure 

you are electrically earthed/

grounded to avoid damaging 

the internal components of the 

handset.  

The handset may 

only

 be 

opened to replace the lithium 

battery within.

HANDSET CHARGING GUIDE

The lithium battery inside the handset is large enough for two rounds of golf, but            

it should be charged after every round

 to ensure sufficient power. 

Always charge the handset indoors and at room temperature, observing the same ‘DO 

and DO NOT’ advice shown on page 9. The charging process can take up to six hours. 

1.  Ensure the handset is switched off and the indicator light is off. 
2.  Remove the protective silicone skin.
3.  Expose the charging port on the side of the handset by pulling out the black plug.
4.  Connect the USB power cable to any 5V USB power outlet.
5.  Connect the USB power cable to the handset & switch on power (if applicable).
6.  The indicator light on the handset will show 

RED

 while charging, and 

GREEN

 when 

fully charged.

7.  Once the indicator light is 

GREEN

, disconnect the power cable from the handset. 

8.  Return the black plug to the charging port on the side of the handset, then refit the 

protective silicone skin.

HANDSET CARE

Using the handset skin and charging port plug means that the handset will be 

showerproof (it is not waterproof). Water and electronics are natural enemies and you 

must take care to make sure no water ever gets inside the handset. 

•  Never allow the handset to be immersed in water and don’t wash it.
•  If you want to wash the silicone skin, remove it from the handset before washing it, 

then dry it thoroughly before replacing it.

•  If you use the handset in the rain or other wet conditions, remove the silicone skin 

as soon as you have finished playing and wipe both handset and silicone skin dry to 

remove any moisture that may have found its way down the edges of the silicone 

skin. Allow both to dry fully before refitting the silicone skin. 

•  Don’t store the handset anywhere that water or moisture might get into it.
•  Refer to the

DO

and 

DO NOT

 guide on page 9 for further advice on how to care for 

the handset and lithium battery contained within. 

LONG TERM STORAGE

If you are not going to use your Q Follow for more than one month, the handset should 

be put through a charge cycle at least once every month. 

This will avoid the handset battery being completely discharged. 

Prior to using the handset again it should be fully charged.  

WARNING

The handset should 

only

 be charged with the supplied USB power cable. Using 

any other cable or power source can damage internal components: this 

will not

be covered under warranty. 

1

2

3

3

4

5

6

7

7

8

9