Stewart Golf X Follow Series, Owner'S Manual

6

7

PUTTING AWAY

Prior to folding, clear any debris from the trolley using compressed air or a soft brush or 

cloth (

never

 use water). Pay particular attention to the base of the main support arms 

for small stones or grit. See the FAQ for a cleaning guide. 

1.  Remove one side of the top bungee and lift your bag up & away from the machine. 

The bottom bungee will release automatically.

2.  Remove the front cover, disconnect and remove the battery and replace the front 

cover.

3.  Release both bottom clips simultaneously by pressing the clips with your thumbs. 

Slowly lower the main support until the top bag support comes to rest on the 

chassis.

4.  Whilst supporting the handle, release the top clip and lower the handle until it 

comes to rest on the rear cover. Do not ‘drop’ the handle or main support.

5.  Lift the X10 Follow in to your car using the lifting points specified.

WARNING:

Always ensure that your X10 Follow is turned 

OFF

 at the switch or disconnected 

completely when not in use. Leaving it 

ON

 or connected could drain the battery 

totally and risk irrecoverably damaging it. 

Turning 

OFF

 or disconnecting the battery will ensure that the trolley is not 

accidentally activated in transit. 

You may choose to remove the battery prior to folding to enable you to charge it.

In any case, it is good practice to always turn the switch to the 

OFF (O)

 position 

when not in use.

6

FITTING YOUR GOLF BAG

1.  Stand the base of your golf bag on the front chassis. 
2.  Ensure the bag cradle is fully lowered, then lean the golf bag back until it rests on 

the silicone bag cushion. 

3.  Pull the upper bungee around the golf bag evenly and fix. 
4.  Pull the lower bag strap over the bottom of the bag using the handle.

Note:

 The X10 Follow has been optimised for use with a cart or tour style bag weighing 

14kg (31lbs). Please refer to page 1 for more information. 

SETTING UP

1.  When removing the X Series from the car, only lift from the two lifting points. These 

are the stabiliser and under the front of the chassis (parts 9 and 16). 

Lifting from 

other parts of the trolley cover could cause unintended damage that will not be 

covered under warranty.

2.  To unfold, simply grip the handle and pull it towards you. The top & bottom clips will 

snap into place automatically.

3.  To remove the front cover, hold the two ‘S’ clips (part 10), apply slight outward 

pressure and lift.

4.  Insert the battery into the tray and secure with the strap. Connect the battery to the 

electronics box.

5.  Replace the front cover by aligning the two lugs on the straight edge with the 

corresponding gaps in the rear cover, and pivot in to place. Ensure the front of the 

cover is behind the small bump near the lower bag stay, apply downward pressure 

to the ‘S’ clips until the cover is secured.

6.  Turn the on/off switch to ‘ON’ (I) and wait for the blue light to flash. Press the 

bluetooth on/off button on the handset for 1 second to switch the handset on. When 

both blue lights are constantly illuminated, the bluetooth connection is established.