LEVEL
(B100K)
10
If any pot has an index pin
protruding from the case,
break it off before installation,
so the pot will mount flush
against the pedal case.
Needle nose pliers work well
for removing the pins.
The last components to go onto
the circuit board are the three
control pots. They install on the
back of the board. Each pot has
three connecting lugs. Note
orientation of each pot.
INSTALL
POTS AND
ATTACH
FOAM TAPE
TIME
Once you’ve removed any index pins and
added the foam tape to the back of each pot,
use the pedal enclosure as a mount for the
control pots while you solder the PCB to them.
Just lay the enclosure face-up and arrange the pots
in their holes, you don’t even need to fasten them
with a nut from the back if you don’t want to.
Use the adhesive foam tape
to insulate the back of the
pots from the soldered
leads of the other parts on
the circuit board. This is
especially important on the
“level” pot.
DEPTH
(B10K)
RATE
(B100K)
SOLDER
POTS TO PCB
11
Solder the pots in place, making sure the foam back stays on the back of the pot.
This insulates the solder joints on the PCB from shorting to the housing of the pot.
.2
2J
63
1J63
.1
J6
3
IN GND SW OUT
