12
Solder the four wires from the bottom of
the printed circuit board to eyelets in the
breakout board as shown.
Solder one end of each 4" wire to the last
two eyelets on the breakout board.
9
ATTACH 6
WIRES TO
BREAKOUT
BOARD
.1
J6
3
.22J63
.1
J6
3
4558D
IN GND SW OUT
INSTALL
FOOTSWITCH
INTO
BREAKOUT
BOARD
8
Orient the breakout board with the text facing
up, reading left to right. Slide the lugs of the
footswitch up through the bottom of the board.
Solder each lug to the breakout board around it.
If the lugs of the footswitch don’t quite fit in the
breakout board, use a pair of pliers to gently bend
the lugs of the footswitch until the breakout board
slides over the lugs.
IN GND SW OUT
IN G
ND S
W OU
T
You can use the pedal
enclosure as a mount for
the footswitch while you
solder the breakout board
to it. Just lay the enclosure face-
up and drop the switch in its
hole. No need to fasten it with
a nut from the back if you don’t
want to.
