14
5mm LED mounting bez
el (1)
#7432
5mm white LED (1)
#7422
case
The LED mounting bezel consists of two main parts:
A ring that the LED fits into, and a plastic plug that goes
over the LED from the back side to keep it in place.
Install the LED mounting bezel using its lock washer
and 3/8” nut. Insert the LED into the bezel with the
flat side (shorter lead) facing right when seen from
inside as shown. Feed the leads through the plastic
plug, and press the plug into the bezel. The LED will
be held in place when you solder the leads in the next
step. For a more secure mount, run a bead of clear
silicone adhesive around the plug.
12
INSTALL
LED
INDICATOR
LIGHT
Like some of the caps and diodes,
the LED is polarized and has to be
installed in a specific direction. The
negative lead of the diode has a flat
edge and is shorter than the positive.
+
+
.1
J6
3
.22J63
.1
J6
3
4558D
IN GND SW OUT
The printed circuit board is held in
place by the control pots, but the
LED leads need to pass through
their eyelets in the printed circuit
board before the pots will pass
through the enclosure.
Pass the longer positive lead
of the LED through the eyelet marked “A” and the
shorter negative lead through the eyelet marked “K”.
Next, secure the pots by installing their shafts through
the enclosure and slide washers onto them on the
outside. Using a 10mm wrench, install the mounting
nuts so they are good and snug, but take care not
to overtighten. Once the pots are secured to the
enclosure, solder the leads of the LED in place.
Install the footswitch through the top of the case and
slide a washer onto it from the outside. Use a 14mm
wrench to tighten it up. The footswitch is the effect
bypass switch that turns the pedal on.
Do not connect any of the lead wires at this point. Once
all of the pots are tightened down, twist the pot shafts
all the way counter-clockwise and install the control
knobs pointing at “7 o’clock” indicating the “zero”
position.
13
INSTALL
PRINTED
CIRCUIT
BOARD
