17
POWER:
Use a standard 9 volt DC power supply with a 2.1mm negative-center barrel (not included).
We always recommend pedal-specific, transformer-isolated, wall-wart power supplies or supplies with
separate isolated outputs. Pedals will make extra noise if there is ripple or unclean power. Switching-type
power supplies, daisy chains, and non-pedal specific power supplies do not filter dirty power as well and
let through unwanted noise. Do not run at higher voltages! Current draw is 25mA.
SENSITIVITY:
Controls the decay of the effect. With a low sensitivity setting you will have to wait longer
for the sound to decay before playing another note will evoke the swell effect.
ATTACK:
Controls how fast the sound swells after the signal hits the circuit of the pedal. A lower attack
setting will produce a very long swell effect, a higher attack setting will produce a much faster swell.
INPUT
OUTPUT
9V DC
ATTACK
SE
NSITIVITY
HERE’S HOW THE CONTROLS WORK
