13
GB
O R I G I N A L I N S T R U C T I O N S
PROPERTIES OF THE TOOL
The manual wood sawing machine is an electric ordinary tool, insulation class II, designed for cutting of wood surfaces and wood
derivatives surfaces – such as plywood, chipboard, MDF boards, etc., using circular saws. The sawing machine permits comfort-
able cutting of wood both in the vertical plane of the processed surfaces within an adjusted range of the cutting depth as well as at
a certain angle within the adjusted range between 0
0
and 45
0
. Cutting may also be carried out along a straight line. It is prohibited
to cut along curves (e.g. in circles), since this might cause an accident or imply damage to the saw and the electric tool. A correct,
reliable and safe operation of the tool depends on its correct use, so:
Read the operating manual thoroughly before work and keep it for future reference.
Attention! Under no circumstances can the tool be operated if the guards of the circular saw and the wedge are not
installed.
The supplier shall not be held responsible for any damage occurred as a result of failure to observe safety regulations and indica-
tions contained in this manual.
ACCESSORIES
The box supplied from the factory contains the following:
- sawing machine
- scaled guide
TECHNICAL PARAMETERS
Parameter
Unit of measurements
Value
Catalogue number
79257
Mains voltage
[V]
230 - 240
Mains frequency
[Hz]
50
Nominal power
[W]
1400
Insulation class
II
Nominal rotation
[min
-1
]
4800
Maximum cutting depth (0
O
/ 45
O
)
[mm]
65 / 44
Circular saw
External diameter
[mm]
182
Internal diameter
[mm]
20
Maximum thickness
[mm]
3,0
Mass
[kg]
4,0
Level of noise
- acoustic pressure L
pA
± K
pA
[dB(A)]
94,0 ± 3,0
- acoustic power L
wA
± K
wA
[dB(A)]
105,0 ± 3,0
Level of vibration (main handle / auxiliary handle) a
h
± K
[m/s
2
]
6,84 ± 1,5
Protection grade
IP20
GENERAL SAFETY CONDITIONS
NOTE!
Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fi re or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean.
Disorder and poor illumination may be a cause of accidents.
Do not work with electric tools in explosive environments, or those which contain infl ammable liquids, gases or vapours.
Electric tools generate sparks, which may cause a fi re in case of contact with infl ammable gases or vapours.
Do not allow children and outsiders to the place of work.
A lack of concentration may result in a loss of control over the tool.
Electric safety
The plug of the power supply cable must fi t the mains socket. Do not modify the plug. Do not use any adapters whatso-
ever in order to adapt the plug to the socket.
Unmodifi ed plug which fi ts the socket reduces the risk of an electric shock.
