ci-321
Page 2 of 2
REV 000
a
2002 STI-CO INDUSTRIES, INC., 11 Cobham Drive, Orchard Park, NY 14127-4187
Technical Support: E-mail: techsupport@sti-co.com Phone: 1-716-662-2680 Fax: 1-800-685-1122
Made in U.S.A.
2. Use figure 3 as a transparent template for correct antenna placement on plastic card.
3. Remove adhesive backing from film using pull-tabs.
Avoid getting fingerprints on adhesive.
4. After adhering film to card, press out any air bubbles.
5. Remove top film protecting the antenna contact points.
6. Peel backing tape from amplifier using pull-tabs.
7. Line up amplifier terminal points with points on the film (Figure 4).
8. Apply pressure for 20-30 seconds.
Adhesive cures in 5 -10 minutes.
9. Use with or with out adhesives. (not supplied) for temporary mounting.
Antenna is not weather resistant.
Figure 3 - GPS Film Antenna Template
Figure 4 Plastic Card Installation
