6
ASSEMBLE INSTRUCTIONS
STEP 6
Connect the
Lower Pulse
Sensor Wire (113)
to the
Middle Pulse Sensor Wire
(112B.)
Remove the
Lock Washer
(M8)(78)
and
Bolt, Button
Head (M8xp1.25x16mm)
(90)
from the
Upright Post
(5).
Insert the
Handlebar (6)
into
the
Upright Post (5)
and
secure with the
Lock
Washer (M8)(78)
and
Bolt,
Button Head
(M8xp1.25x16mm)(90)
on
each side as the drawing
shown.
STEP 7
a.
Loosen the
Screw (M3x10mm)(79)
at the bottom on the console by using the combination wrench to open the
Battery Door (16.)
b. The
Console (13)
operates with FOUR AA rechargeable batteries, four batteries are included in the hardware
box.
The machine is suitable for
Nickel-Metal Hybrid/NI-MH
rechargeable batteries only.
c.
Install rechargeable batteries into the console.
STEP 8
Attach the
Battery Door (16)
onto the back of the
Console (13)
with the
Screw (M3x10mm)(79.)
STEP 9
a. Connect the
Middle Pulse Sensor Wire (112A)
to the
Middle Pulse Sensor Wire (112.)
b. Connect the
Middle Connection Wire (109A)
to the
Middle Connection Wire (109.)
Note the number of wire pin should be the same for both wires to connect with as the illustration shown below
STEP 10
Place the
Console (13)
onto the
Upright Post (5)
and secure with the
Screw, Round Head
(M5xp0.8x15mm)(83.)
STEP 11
Attach the
Console Lower Case (15)
to the
Console (13)
and secure with the
Screw, Round Head
(M5xp0.8x15mm)(83.)
NOTE:
To prevent from any damages, general batteries and other type of
batteries are not allowed.
Summary of Contents for PR-7020
Page 34: ...33 PRODUCT PARTS DRAWING ...
