13
Assembly collectors
For the collector assembly, you first set the rightmost or leftmost
collector on the mounted and fixed consoles. When mounting the
collector ensure that the outer console is covered about 50% by the
collector.
After the exact orientation the collector is fixed on the outside with
fastening plates at the upper and lower elongated hole on the
console.
1400008 Collector fastening set onto support
edge (2 fastening points)
Please note that the remaining fastening plates are to mount on the
opposite outer side.
Before the following collectors can be mounted, the compensator
must be mounted on the concisely protruding flange.
It is important to ensure that the 0-ring seal is used for the
compensator.
1300001 Collector connection set hydraulical
Fixation of the compensator on one side with the clamp.
Before tightening the screw the clamp must be positioned by a
rotary motion up and down Tighten the screw on the clamp only
manually. The use of cordless drills or similar may cause damage
to the thread of the clamp. Tighten the clamp until the two lugs
superimpose in the whole length.
1910001 Tool set
Afterwards, mount the fastening plate “double” on the next console
in the upper and lower elongated hole. The final fixation takes place
after assembly of the next collector.
1400006 Collector fastening set onto support
(2 fastening points)
