18
Assembly of the plain tile clamps
with lead
Fixation of the lower lath 24 x 80 x 600 mm with two screws
5 x 60 mm.
When mountig the field in regions with high snow load
zone of more than 2 kN/m², it is necessary to place
the roof hooks in the rafter area.
Assembly of the lower tile clamp support 80 x 50 x 45 mm with
two screws 5 x 60 mm.
When assembling, there will be a timber excess length of 5 mm
(timber will be higher than tile).
Completely mounted timber supports.
Mounting of the lower lead sheet while placing the lead laterally
under the tiles.
