14
Prefabricated cuts at the bottom of the
collector covering
Cuts are here
Assembly of the intermediate
plates/ multi-row collector fields
Multi-row collector fields
To attain a homogenous appearance of the collector installation, the assembly of sheets between the collectors is possible.
The intermediate plates are exclusively assembled due to optical aspects and do not have a functional impact on the
installation. This is the reason why the intermediate plates can be ordered optionally and are not necessarily included in
the delivery contents.
When assembling multi-row collector fields, the collectors in the rows above the other rows will always be mounted edge
to edge. To subsequently be able to assemble the intermediate sheets without any problems, the lip (collector covering) of
the lowest collector has to be cutted out at the respective parts.
For the assembly of the intermediate plate, the prepared cut of
the lip (collector covering) will be cutted out at the respectively
lowest collector. Thereby, you have to pay attention that only
the cuts which lie horizontally will be cutted out. Cuts will only
be processed where an intermediate plate will be assembled.
For the assembly of the collectors in multiple rows as well as
for the assembly of curved intermediate plates, the processing
at the outside of the collector field is necessary as well.
The cuts which have to be made are marked at the bottom:
V: Cut for vertical collectors
H Cut for horinzontal collectors
Cut out the lip (collector covering) with a knife at the respective
and prepared cuts.
Summary of Contents for FKF 200
