STICKY BRICK
JUNIOR
USER GUIDE
EXPERIMENT!
Vapor production is dependent on several variables: draw
speed, flame length and position, carb airflow, material
quality, grind, and ambient temperature. Use of different
accessories may also affect vapor production.
Try changing one thing at a time to help find your preferred
method of use.
MAINT
E
N
ANCE
•
Gently clean wood components with a cotton swab and
warm water, then dry thoroughly. Do not clean wood parts
with ISO alcohol and only condition the wood with Sticky
Brick Butter (available for purchase at stickybricklabs.com).
•
Glass components and screens should be removed from the
Brick and cleaned with ISO alcohol as needed.
•
When reassembling your Brick, insert o-rings into the wood
before the glass for best seal.
WARRANTY & CONTACT
We offer a lifetime warranty on wood bodies, a 15-day
warranty on glass, and will always offer replacement parts.
email: productsupport@stickybricklabs.com
phone: 828.399.0299
Our new 316 stainless steel Restrictor Disc protects
the wood from direct flame and enables the use of
longer/bigger flames with very little learned
technique. Our goal was to find something that fits
in all units and greatly reduces the chance of
combustion, while also remaining removable for
experienced users who want more control.
1. Remove flame intake and o-ring.
2. Place restrictor disc into the flame intake brick,
flat side up/cylinder down towards the bowl/
screen*
3. Insert o-ring followed by the flame intake.
4. Note: you may need to increase flame size.
*Some older units will have a smaller hole in which case
the restrictor disc can be turned over, with the cylinder
pointing upwards into the flame intake.
