CARB CORK
(OPTIONAL)
BASE
CARB
CHAMBER
SCREEN
TOOL PORT
AIR INTAKE
MIDSECTION
O-RINGS
HEAT INTAKE
MOUTHPIECE
LID
INNER LEDGE
STICKY BRICK
JUNIOR
~1"
INNER FLAME
OUTER FLAME
C
HEAT
INTAKE
A
B
D
E
PREPARE
•Remove lid and set aside.
•Rotate mouthpiece and heat intake outward
(A). For roomier setup, remove mouthpiece
and insert opposite end into midsection
(B). Heat intake can be angled left or right
for comfort.
•Adjust torch so overall flame length is ~1".
LOAD
Separate the midsection from the base to
expose chamber. Load ground material
loosely into chamber, no higher than the
inner ledge, so it evenly covers the screen.
Reassemble the Bricks.
OPERATE
•
•
•
Aim torch flame down heat intake, and
position flame so the light blue outer flame
is flush with, or just inside, the intake (C).
Cover carb and draw slowly until you see/
taste/feel vapor
, then i
ncrease draw speed.
As you finish the draw, remove torch and
open carb.
•Stir material between draws as needed.
•Do not cover air intake on the side of the
unit as it provides needed, continuous
airflow. Glass retains heat, so do not
touch heat intake immediately after use.
OPTIONS
•The included carb cork (D) can be used to
block the carb to free up a hand and
produce thicker vapor.
•The U-joint WPA (E) is available for
purchase at stickybricklabs.com and lets
you connect your Sticky Brick Junior
directly to your favorite 14.4mm glass.
