INsTALLATIoN
Alternative installation methods
38
| DEL Plus www.stiebel-eltron.com
13.7 Fitting appliance cover for water installation on
finished walls
D
00000
73
17
0
4
3
2
1
1 Back panel guides
2 Screw
3 Cover guides with sealing lips on the pipe side
4 Pipe knock-out
f
f
Cleanly saw and break out the pipe knock-outs in the appli-
ance cover. If necessary, use a file.
f
f
Click the cover guides into place in the knock-outs.
Only if using the "solder fitting" accessory and with precise
adherence to all installation dimensions:
f
f
Break the sealing lips out of the cover guides.
f
f
Position the back panel guides on the pipes. Push them to-
gether. Then push the guides against the back panel as far
they will go.
f
f
Secure the lower back panel section with a screw.
Note
You can use the cover guides with sealing lips to com-
pensate for a slight offset of the connection pipes and/
or if using the "press fitting" accessory. In this case, the
back panel guides are not fitted.
13.8 Lower back panel section installation with
threaded fittings on finished walls
D
00000
53
28
6
2
3
1
1 Lower back panel section
2 Connection piece in the standard delivery
3 Screw
If using threaded fittings on finished walls, the lower back panel
section can also be installed after fitting the taps. To do this, carry
out the following steps:
f
f
Cut open the lower back panel section.
f
f
Fit the lower back panel section by bending it out at the sides
and guiding it over the pipes.
f
f
Insert the connection pieces into the lower back panel sec-
tion from behind.
f
f
Click the lower back panel section into place.
f
f
Secure the lower back panel section with a screw.
13.9 Wall mounting bracket when replacing an
appliance
An existing STIEBEL ELTRON wall mounting bracket may be used
when replacing appliances (except the DHF instantaneous water
heater), as long as the fixing screw is in the lower right position.
Replacing a DHF instantaneous water heater
26
�0
2�
02
�0
81
5�
f
f
Reposition the fixing screw on the wall mounting bracket (the
fixing screw has a self-tapping thread).
f
f
Rotate the wall mounting bracket 180° and mount it on the
wall (the DHF logo is then turned towards you).
13.10 Installation with offset tiles
11
0
20
26
�02
�02
�1
06
6�
2
1
1 Minimum contact area of the appliance
2 Maximum tile offset
f
f
Adjust the wall clearance. Lock the back panel in place using
the fixing toggle (turn 90° clockwise).
13.11 Pivoting appliance cover
The appliance cover should be turned round for undersink in-
stallation.
D
00000
73
01
2
f
f
Remove the programming unit from the appliance cover by
pressing the locking hooks and removing the programming
unit.
