iNSTallaTiON
Cleaning, care and maintenance
www.stiebel-eltron.com
HSBB 200 S (GB) |
5
OK
MENU
D
00000
64
71
1
6. Cleaning, care and maintenance
f
f
Have the electrical safety of the appliance and the function
of the safety assembly regularly checked by a qualified
contractor.
f
f
Have the protective anode checked by a qualified contractor
after the first two years of use. The qualified contractor will
then determine the intervals at which repeat checks should
be performed.
f
f
Never use abrasive or corrosive cleaning agents. A damp
cloth is sufficient for cleaning the appliance.
Scaling
Almost every type of water will deposit limescale at high tem-
peratures. This settles inside the appliance and affects both the
performance and service life. A qualified contractor who knows
the local water quality will tell you when the next service is due.
f
f
Check the taps regularly. Limescale deposits at the tap out-
lets can be removed using commercially available descaling
agents.
f
f
Regularly activate the safety valve to prevent it from becom-
ing blocked, e.g. by limescale deposits.
7. Troubleshooting
problem
Cause
remedy
The water does not heat
up. The heating does not
work.
There is no power.
Check the fuses/MCBs in
your fuse box/distribu-
tion panel.
If you cannot remedy the fault, notify your qualified contractor.
To facilitate and speed up your request, provide the number from
the type plate (000000-0000-000000).
No.: 000000-0000-000000
Made in Germany
D
00000
70
86
2
iNSTallaTiON
8. Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
8.1 General safety instructions
We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
8.2 Instructions, standards and regulations
Note
Observe all applicable national and regional regulations
and instructions.
9. Appliance description
9.1 Standard delivery
The following are delivered with the appliance:
- Operating and installation instructions for the WPM heat
pump manager
- Outside temperature sensor AF PT
- 4 adjustable feet
- 1 expansion vessel (incl. fastening material)
- 1 installation kit (pressure reducing valve, check valves, ex-
pansion relief valve, tundish)
9.2 Accessories
Required accessories
Safety assemblies and pressure reducing valves are available
to suit the prevailing supply pressure. These type-tested safety
assemblies protect the appliance against impermissible excess
pressure.
Required for area cooling:
- Temperature sensor PT1000
- FET remote control
Further accessories
- Remote control for heating operation
- High limit safety cut-out STB-FB
- Pressure hoses
- Water softener HZEA
- Segmented anode
