INsTALLATION
Installation
24
| CON Premium | CON Premium U
www.stiebel-eltron.com
f
Lift up the wall mounting bracket so that its lower holes
match up with the markings you have just made on the in-
stallation wall.
f
Mark holes 3 and 4 on the installation wall.
f
Drill the holes at the 4 markings.
f
Secure the wall mounting bracket with suitable fixing ma-
terials (screws, rawl plugs). With the vertical slots, you can
compensate for an offset fixing hole.
10.3 Appliance installation
D
00000
74
78
2
1
1 Wall mounting bracket
f
Hook the appliance onto the bottom tabs of the wall mount-
ing bracket by the slots in the back of the appliance.
f
Place the appliance in an upright position.
f
Secure the appliance by pushing it towards the wall until it
audibly snaps into place in the two upper springs on the wall
mounting bracket.
D
00000
74
78
3
2
1
1 Appliance
2 Locking screw
f
Secure the appliance against unintentional release using the
supplied locking screw on the right or left-hand side of the
wall mounting bracket.
10.4 Removing the appliance
f
Undo and remove the locking screw from the wall mounting
bracket.
f
To release the appliance, push down the springs at the top of
the wall mounting bracket.
f
Tilt the appliance away from the wall and lift it off the bottom
tabs on the wall mounting bracket.
10.5 Electrical connection
WARNING Electrocution
-
Carry out all electrical connection and installation
work in accordance with relevant regulations.
-
In the case of a permanent connection, the appli-
ance must be able to be separated from the power
supply by an isolator that disconnects all poles with
at least 3 mm contact separation.
-
Do not install the appliance with a fixed power
cable.
Material losses
- Observe the type plate. The specified voltage must
match the mains voltage.
- Ensure the on-site supply cable has an adequate
cross-section.
10.5.1 CON Premium series
The appliance is delivered fully wired. The following electrical
connections are permissible:
CON 5-30 Premium
Connection to a freely accessible standard socket
with matching plug
X
Permanent connection to an appliance junction box
with earth conductor
X
Connection to a standard socket
D
00000
76
07
3
1
1 Retainer for power cable
Material losses
The power cable must not be pushed into the space be-
tween the appliance back panel and the wall on which
it is installed.
f
Wind up any surplus power cable around the cable
retainer at the back of the appliance.
f
Plug the appliance into a standard socket.
