oPerATIoN
General information
LA 60 Trend | LA 60 Plus
| 21
ENGL
IS
H
oPerATIoN
1. General information
The chapters "special information" and "operation" are intend-
ed for appliance users and qualified contractors.
The chapter "Installation" is intended for qualified contractors.
Note
read these instructions carefully before using the ap-
pliance and retain them for future reference.
Pass on these instructions to a new user if required.
1.1 Safety instructions
1.1.1 Structure of safety instructions
!
KEYWORD Type of risk
Here, possible consequences are listed that may re-
sult from failure to observe the safety instructions.
f
Steps to prevent the risk are listed.
1.1.2 Symbols, type of risk
Symbol
Type of risk
Injury
electrocution
Burns
(burns, scalding)
1.1.3 Keywords
KEYWORD
Meaning
dANGer
Failure to observe this information will result in serious
injury or death.
wArNING
Failure to observe this information may result in serious
injury or death.
CAUTIoN
Failure to observe this information may result in non-se-
rious or minor injury.
1.2 Other symbols in this documentation
Note
Notes are bordered by horizontal lines above and
below the text. General information is identified by
the adjacent symbol.
f
read these texts carefully.
Symbol
damage to the appliance and environment
Appliance disposal
f
This symbol indicates that you have to do something. The
action you need to take is described step by step.
1.3 Standardised output data
Information on determining and interpreting the specified
standardised output data
Standard : DIN 18017-3
The output data specifically mentioned in text, diagrams and
technical datasheet has been determined in line with the test
conditions specified in the standard shown in the heading of
this chapter.
Generally, these standardised test conditions will not fully meet
the conditions found at the installation site of the system user.
depending on the chosen test method and the extent to which
the selected method deviates from the conditions specified
in the standard shown in the heading of this chapter, any de-
viations can have a considerable impact. Additional factors
that have an influence on the test values are the measuring
equipment, the system configuration, the age of the system
and the flow rates.
A confirmation of the specified output data can only be ob-
tained if the conditions applicable to the relevant test match
those of the standard shown in the heading of this chapter.
1.4 Units of measurement
Note
All measurements are given in mm unless stated oth-
erwise.
!
!
