STIEBEL ELTRON SHC 10 AU, Operation And Installation Manual

8

 | SHC 10 AU  |  SHC 15 AU www.stiebel-eltron.com

INSTALLATION 

Maintenance

13.3  Opening the appliance

D

00000

50

29

3

f

f

Remove the 4 screws from the casing.

f

f

Open the appliance cover by pivoting the cover upwards and 

then removing it.

f

f

Remove the upper insulation semi-shell if required.

Note

The appliance is factory-set to the maximum tempera-

ture.

f

f

Never change the factory-set temperature setting.

13.4  Removing the flanged immersion heater and 

temperature controller / high limit safety cut-

out

D

00000

50

29

5

1

2

1  Flanged immersion heater

2  Combined temperature controller / high limit safety cut-out

f

f

Remove the combined temperature controller / high limit 

safety cut-out from the flanged immersion heater.

f

f

Remove the flanged immersion heater.

13.5  Removing the protective anode

D

00000

50

29

6

1

1  Protective anode

f

f

Remove the protective anode.

13.6  Fitting the flanged immersion heater and 

temperature controller / high limit safety cut-

out

D

00000

50

29

4

f

f

Insert the flanged immersion heater into the cylinder aper-

ture well as far as it will go.

f

f

Push the combined temperature controller / high limit safety 

cut-out into the flanged immersion heater as far as it will go.

f

f

Align the flanged immersion heater and the combined tem-

perature controller / high limit safety cut-out in accordance 

with the diagram.

f

f

Turn the shaft of the temperature controller anti-clockwise as 

far as it will go.

13.7  Descaling the appliance

!

Material losses

Never treat the protective anode with descaling agents.

f

f

Remove the flanged immersion heater.

f

f

Remove the protective anode.

f

f

Carefully tap the heating element to remove coarse limescale 

deposits.

f

f

Immerse the heating element up to the flange plate in desca-

ling agent.