background image

- 2 -

CARE AND MAINTENANCE

You have purchased a quality product that will give you years of enjoyment. By following these simple

maintenance steps, you will add to the life of your new table.

The top (playing surface) of your table is made of Particle Board. Like all products made of wood, it

can be affected by atmospheric changes in both temperature and humidity. This may cause a slight

sag or distortion as the top expands or contracts. This is normal and should not cause concern as it

does not detract from the play or utility value of the table. After assembly of the table, you can minimize

the effects of temperature and humidity changes by storing the table in a dry area when table is not

in use.

This table must be stored indoors to prevent damage to the playing surface. Dampness and extreme

temperature changes can cause the wood to warp, swell, crack or blister. When your table is not in

use, it should be stored in a dry area. Due to the nature of particle board, table top may bow.

Damp and humid conditions will amplify this. This is normal and will not affect playability of table.

THE TABLE TOP

STORAGE OF YOUR TABLE

To clean your table use a soft, damp (NOT WET) cloth only. To prevent damage to your table’s playing

surface, DO NOT USE ANY CHEMICALS, ABRASIVE OR CLEANING PRODUCTS on your table’s playing

surface.

CLEANING YOUR TABLE

Be sure to oil all moving parts of your table including the pivot points. This will insure the safety and ease

of use of your table.

MAINTENANCE OF YOUR TABLE

If table does not seem level, it is probably due to uneven or unlevel floors. Set the table in its PLAYING

POSITION and move table several inches in different directions to find the best location for the table.

If the floor is extremely unlevel, table may not play or operate properly.

If table is high in the center, shim up under the outer legs.

UNLEVEL FLOORS

This table must be kept indoors to prevent damage to the playing surface. Dampness and extreme

temperature changes which occur on patios or similar areas can cause wood to warp, swell, crack or

blister.

It is recommended to keep the carton for folded table storage and or transport.

Also, note when folded, the table has casters on the bottom side to make movement easier.

When transporting the folded half tops, be careful not to damage the lower corners or scratch the playing

surfaces.

TRANSPORTING THE FOLDED TABLE TOPS

Summary of Contents for Play The Best T8485F











Reviews: