7
16
16
18
Hinge Assembly
18
Hinge Assembly
21
17
17
38
Plastic Washer goes
between Strut Tube
(#17) and Hinge (#18)
40
16
19
CAUTION
: Position hinges exactly as
shown in
Detail L
or table will not
operate correctly and could be damaged.
34
38
30
18
17
30
38
34
30
18
17
Detail B
ATTENTION: If hinge is positioned as
shown below (
Detail B
), Rotate the hinge
as shown in
Detail C
. Do not take hinge off.
Detail C
Incorrect position
of hinge
Correct position
of hinge
Figure 6
In the correct position
Hinge #18 will look like a
V when attached to Strut
Tube (#17).
10.
Attach Hinges (#18) to Strut Tubes (#17) as shown in
Figure 6
&
Detail C
.
With hinge positioned as shown, align hole in hinge with hole in Strut Tube and
attach with ¼ Screw (#30), Plastic Washer (#38) and Locknut (#34). Plastic
Washer (#38) goes between Strut Tube and Hinge. Tighten nut securely. Repeat
for other Hinge.
CAUTION: Hinges must be positioned exactly as
shown or table will not operate correctly and could be damaged.
12.
With at least two adults
, repeat steps 7 through 11 for other table top assembly.
DO NOT OPEN THE TABLE TO PLAYING POSITION UNTIL
BOTH TOPS ARE INSTALLED! DO NOT LEAVE TABLE
STANDING UNATTENDED. IT COULD BE KNOCKED OVER
CAUSING SERIOUS BODILY INJURY OR PROPERTY DAMAGE.
Note:
rotate the hinge to the position shown in Detail C. DO NOT unscrew the
hinge, you can rotate the hinge without unscrewing it from the table.
If hinge (#18) is positioned as shown in Detail B, you will have to
If you want to see a video on how to position hinge (#18) go to:
http://www.escaladesports.com/customer-service/videos.html
Or
Scan with your smartphone:
11.
Attach Corner Protector (#40) to table corners. Push snap tabs on Corner Protector
into holes in rails.
Be sure that tabs are aligned with holes before pushing
.
You could break tabs if not aligned correctly.
