page
46
Release 00 - 03/2018
Engine RS100 - RSC100
Service manual
14. ENGINE BLOCK - External operations
13
14.3. Dismantling and replacing the complete
fan
1 - Remove the starter assembly
.
2 - Operate the exhaust brake.
3 - Using an airgun, undo the nut (
13
).
4 - Undo the screw (
14
) and the stud (
15
) and re-
move the electronic coil (
16
).
5 -
Using a suitable extraction tool, remove the
complete fan (
17
) as indicated in the diagram.
Ensure that the engine shaft key is retained.
NOTE: If it is difficult to disassemble the fan,
use a hammer and hit the extractor screw.
6 - When fitting the complete fan check that the key
(
18
) is in good condition and replace it, if deformed.
Close the nut (
13
) to the indicated couple.
7 - Refit the coil (14
), tightening the screw (
15
) and
the stud (
16
) to the torque indicated.
8 - Readjust the airgap until it is correct
.
9 - Refit the starter assembly
17
15
14
16
18
<< BACK >>
INDEX