1. PACKAGING CONTENTS
The packaging contains:
– power unit,
– bar,
– chain,
– bar cover,
– bag containing documents.
IMPORTANT
The machine is supplied with
the bar and chain dismantled and the oil tank
empty.
WARNING!
Unpacking and complet-
ing the assembly should be done on a flat and
sta ble surface, with enough space for ma
chi ne handling and its packaging, always
making use of suitable equipment.
Disposal of the packaging should be done in
ac cordance with the local regulations in for ce.
2. BAR AND CHAIN MOUNTING
WARNING!
Always wear heavy-duty
gloves when handling the bar and chain.
Mount the bar and chain very carefully so as
not to impair the safety and efficiency of the
m achine. If in doubt, contact your dealer.
Before fitting the bar, make sure the chain brake is
not engaged; this is done by pulling the front hand
guard right back towards the body of the machine.
WARNING!
Make sure the machine is
not plugged into the mains socket.
– Unscrew the handle (1) and remove the guard
to get to the drive sprocket and the point where
the bar is fitted (Fig. 1).
– Mount the chain in the right direction on the bar.
If the tip of the bar has a nose sprocket, make
sure the drive links are correctly inserted in the
sprocket rims (Fig. 2).
– Mount the bar (2) inserting the stud bolt in the
bar’s slot using the tension adjuster (2a); move
the bar towards the back of the machine body
(Fig. 3).
– Wind the chain around the drive sprocket (Fig.
4) and push the bar forward to achieve an initial
tensioning of the chain.
– Fit the guard back on, screwing on the knob (1)
without tightening it.
– Turn the ring (3) clockwise until you find the right
chain tension (Fig. 5).
– Raise the bar and tighten the knob (1) securely
(Fig. 6).
6
MACHINE ASSEMBLY / PREPARING TO WORK
EN
4. MACHINE ASSEMBLY
1. CHECKING THE MACHINE
WARNING!
Make sure the machine is
not plugged into the mains socket.
Before starting work please:
– check that the mains frequency and voltage is
the same as the rating data on the “identification
plate” (see chap. 1 - 10.8);
– ccheck that all the screws on the machine and
the bar are tightly fastened;
– check that the chain is tensioned correctly,
sharp and there are no signs of any damage;
– check that handgrips and protection devices
are clean and dry, correctly mounted and well
fastened to the machine;
– check that the chain brake is working efficiently;
– check that the trigger switch and the safety
button should move freely without forcing and
return automatically and rapidly back to their
neutral position;
– check that the trigger switch must remain locked
until the safety button is pressed;
– make sure the cooling air vents are not clog ged
up with sawdust or debris;
– check that the power cable and extension lead
are not damaged;
– check that the chain’s oil level is not below the
«MIN» level mark and top up to 1 cm from the
rim of the filler if necessary.
2. CHECKING THE CHAIN TENSION
WARNING!
Make sure the machine is
not plugged into the mains socket.
5.
PREPARING TO WORK
All manuals and user guides at all-guides.com
