10
1. Net Post Assembly
Attach plastic net post as shown with washer and knob. Note:
there is a left and right net post assembly (See Net System
Description). Post assembly should rest flat against nut plate.
Slide the net sleeve over the vertical post while the net post
assembly is folded in toward the side of the table top. Fold the
net post assembly out against the net post stop into the post
and secure bead chain in catch.
Nut
Washer
Knob
Net Post Assembly
Catch
Tabs
Bead
Cord
Sleeve
Height
adjustment
slot
A
B
C
Net System Description
2. Adjustments
A - Adjust overall net tension by slightly loosening the knob and moving
net post assembly. Moderately tighten knob. Net post assembly should
be kept square with the table by the net post stop (See Net System
Description).
B - Adjust tension of cord with bead chain on each side. Assure that
chain is fully seated in catch.
C - Position top of net to a regulation height of 6” from the table surface
by firmly gripping the vertical net post within height adjustment slot.
Bottom of table top
in vertical position
Net Post Stop
Nut Plate
Left Net Post
Assembly
Right Net Post
Assembly
