4. A)
Attach two Square Legs (
#1
) between Leg Mounting Brackets (
#23
) and Leg Mounting Bracket &
Brace Assemblies (
#6
) using two Hex Head Bolts (
#21
), four Plastic Flat Washers (
#24
)
and two Locknuts (
#14
) as shown in
FIGURE 4
&
DETAIL A
.
Attach middle holes of two Square Legs (
#1
) to Leg Mounting Bracket & Brace Assemblies (
#6
)
using two Phillips Rd. Hd. Bolts (
#17
), two Flat Washers (
#37
) and two Locknuts (
#19
) as shown in
FIGURE 4
&
DETAIL A
.
B)
Install one Hex Nut (
#27
) to each Leg Leveler
(
#28
). Then install Leg Levelers to Square Legs
as shown in
FIGURE 4
.
Repeat for other Table Top.
Parts Needed:
2 pcs -
#1
Square Leg-Silver
1 pc -
#2
Aluminum Top Assembly
2 pcs -
#28
Leg Leveler
Figure 4
Hardware Needed:
2 pcs -
#14
Locknut
2 pcs -
#17
Phillips Rd. Hd. Bolt
2 pcs -
#19
Locknut
2 pcs -
#21
Hex Head Bolt
4 pcs -
#24
Flat Plastic Washer
2 pcs -
#27
Hex Nut
2 pcs -
#37
Flat Washer
6
17
21
24
14
37
19
23
6
DETAIL A
1
Middle of table is
end without stripe.
NOTE:Hole is not on center and
must be assembled as shown with
offset hole toward middle of table.
1
28
27
17
21
24
14
37
19
23
6
Do not use
bottom two holes.
