22.
Attach Hinges (#18) to Strut Tubes (#17) as shown in
Figure 12
&
Detail N
. With hinge positioned as shown, align hole in hinge with
hole in Strut Tube and attach with ¼” Screw (#30), Plastic Washer
(#38) and Locknut (#34). Plastic Washer (#38) goes between Strut
Tube and Hinge. Tighten nut securely. Repeat for other Hinge.
CAUTION: Hinges must be positioned exactly as shown or
table will not operate correctly and could be damaged.
23.
With at least two adults
, repeat steps 19 through 22 for other
table top assembly.
DO NOT OPEN THE TABLE TO PLAYING POSITION UNTIL
BOTH TOPS ARE INSTALLED! DO NOT LEAVE TABLE
STANDING UNATTENDED. IT COULD BE KNOCKED OVER
CAUSING SERIOUS BODILY INJURY OR PROPERTY DAMAGE.
30
38
34
30
38
Plastic Washer goes
between Strut Tube
(#17) and Hinge (#18)
18
Hinge Assembly
18
Hinge Assembly
CAUTION
: Position hinges exactly as
shown in
Detail N
or table will not
operate correctly and could be damaged.
34
38
30
18
17
18
17
Detail M
ATTENTION: If hinge is positioned as
shown below (
Detail M
), Rotate the hinge
as shown in
Detail N
. Do not take hinge off.
Detail N
Incorrect position
of hinge
Correct position
of hinge
In the correct position
Hinge #18 will look like a
“V” when attached to Strut
Tube (#17).
Note: If hinge (#18) is positioned as shown in Detail M, you will have to
rotate the hinge to the position shown in Detail N. DO NOT unscrew the
hinge, you can rotate the hinge without unscrewing it from the table.
If you want to see a video on how to position hinge (#18) go to:
http://www.escaladesports.com/customer-service/videos.html
Or
Scan with your smartphone:
Figure 12
12
17
17
