Stihl ALM 030 Instruction Manual Download

Page: 7 / 70

0478 909 9928 A - EN

Mowing blade ALM 030

The accessory

ALM 030

enables the lawn

to be cut more quickly since it increases
the cutting width of the robotic mower by
2 cm.

For this purpose, the mowing blade with a
cutting width of 28 cm installed as
standard and the carrier plate on the
robotic mowers from the

RMI 632

series

are replaced with a mowing blade with a
cutting width of 30 cm and a blade support.

Notes on the instruction manual:

This instruction manual constitutes

original manufacturer's instructions

the sense of EC Directive 2006/42/EC.

STIHL is continually striving to further
develop its range of products; we therefore
reserve the right to make alterations to the
form, technical specifications and
equipment level of our standard
equipment.
For this reason, the information and
illustrations in this manual are subject to
alterations.

This instruction manual is protected by
copyright. All rights reserved, especially
the right of reproduction, translation and
processing using electronic systems.

General

These safety regulations must
be observed when working with
the machine.

Read the entire instruction
manual before using the
machine for the first time. Keep
the instruction manual in a safe

place for future reference.

In addition, the entire instruction manual
for the robotic mower must be read. This
instruction manual supplements the
instruction manual for the robotic mower.

A robotic mower with fitted accessory

ALM 030

is intended for mowing lawns.

The supplied mowing blade (cutting width
30 cm) must only be used together with
the blade support also supplied. Other
combinations are not permitted.

●

Tilt the robotic mower onto its side and
lean it securely against a stable wall.

Removing the mowing blade

and carrier plate

●

Push in both tabs (1) on the
carrier plate with one hand and
hold. Remove fastening nut (2) with
your other hand. Remove the mowing
blade together with the fastening nut.

●

Insert puller (3) into the carrier plate as
shown and turn anti-clockwise to the
stop.

●

Support the machine with one hand,
remove carrier plate (4) by pulling on
puller (3).

3.2 Installing ALM 030

Installing the blade support

●

Thoroughly clean the mowing
deck and shaft of the motor.

●

Fit blade support (B) onto the shaft of
the motor as shown.

Installing the mowing blade

●

Fit mowing blade (A) on blade
support (B) as shown. Ensure correct
position of retainers (1) in the mowing
blade. The guides (2) must be
positioned in the slot of the mowing
blade as shown.

●

Screw on new fastening nut (C) as far
as possible. Several clicks are audible
during tightening. Ensure secure
seating of the mowing blade by shaking
carefully.

. For your safety

Printed on chlorine-free bleached paper. Paper is recyclable. Cover is halogen free.

Risk of death from suffocation!

Packaging material is not a toy -
danger of suffocation! Keep
packaging material away from
children.

2. Standard equipment

Item Designation

Qty.

Mowing blade

Blade support

Fastening nut

–

Instruction manual