FBD-KM
English
10
Mounting the Gearbox
N
Loosen the clamp screw (1) on the
gearbox (2) – do not remove it.
N
Push the drive tube (3) into the
gearbox, turning it back and forth at
the same time.
N
Once the end of the drive tube is
inserted beyond the slot in the
clamp (4), push it fully home as far
as stop.
N
Tighten down the clamp screw
moderately.
N
Line up the drive tube (3) in the
gearbox (2) so that the lug (arrow)
on the drive tube points vertically
upwards when the depth wheel (5)
is upright.
N
Tighten down the clamp screw
firmly.
N
Push the lug (1) on the drive tube
into the slot (2) in the coupling
sleeve as far as stop.
When correctly installed, the red line (3)
(arrow point) must be flush with the end
of the coupling sleeve.
N
Tighten down the star knob (4)
firmly.
Removing the KombiTool
N
Reverse the above sequence to
remove the drive tube.
1
9924BA009 KN
2
4
9924BA010 KN
9924BA01
1 KN
3
5
2
Mounting the KombiTool
1
002BA326 KN
2
3
002BA327 KN
4
