6
Assembling the Trimmer
6.1
Assembling the Carrying Sys‐
tem
4
5
3
4
1
2
0000-GXX-8172-A0
► Fit the sleeve (1) over the frame (2).
► Wrap the straps (4) around the crossbar (3).
► Thread the straps (4) through the fasteners
(5).
► Tighten the straps (4).
The carrying system need not be removed again.
6.2
Mounting the Powerhead
► Shut off the engine.
4
1
1
2
3
5
0000-GXX-7838-A0
► Unscrew the nut (1).
► Hold the powerhead against the carrying sys‐
tem (5) so that the flexible drive tube (4) points
to the right.
► Insert the threaded rod (3) in the hole.
► Fit and tighten down the nut (1) firmly.
The powerhead need not be removed again.
6.3
Mounting the Drive Tube
► Shut off the engine.
1
1
3
2
2
0000-GXX-7839-A0
► Take out the screw (2).
► Hold the coupling sleeve (1) against the end of
the drive tube (3) and turn it until it can be
pushed onto the drive tube.
► Push the coupling sleeve (1) onto the drive
tube (3) as far as stop.
► Insert and tighten down the screw (2) firmly.
5
6
4
6
0000-GXX-7840-A0
► Secure throttle cable (4) to flexible drive tube
(5) with the cable retainers (6), making sure
the throttle cable (4) is not wrapped around
the drive tube (5).
6.4
Mounting the Loop Handle
► Shut off the engine.
a
4
5
1
6
7
3
2
0000-GXX-7841-A0
► Fit the clamp (4) in the loop handle (3).
► Place the loop handle (3) with clamp (4) on the
shaft (5).
► Fit washers (2) on the screws (1).
► Hold the clamp (6) against the shaft (5).
► Insert screws (1) through holes in the loop
handle (3) and clamps (4 and 6).
► Fit the nuts (7).
► Slide the loop handle (3) on the drive tube until
distance ‘b’ is no more than 20 cm.
► Tighten down the nuts (7) firmly.
6 Assembling the Trimmer
English
0458-527-0121-B
11
