HLE 71, HLE 71K
English
35
N
Loosen the clamp screws (1).
N
Line up the sliding sleeve (2) – it
must be in line with the opening in
the angle drive.
N
Push the gearbox (3) onto the drive
tube (4), turn the gearbox back and
forth as necessary.
N
Once the end of the drive tube is
inserted beyond the slot in the
clamp (5), push the gearbox fully
home.
N
Tighten down the clamp screws
moderately.
N
Line up the gearbox (3).
N
Tighten down the clamp screws
firmly.
Adjustment mechanism 125°
In this version, the angle of the cutting
bar relative to the shaft is adjustable
from 0° (completely straight) to 45° (in
4 stages upward) and to 80° (in 7 stages
downward). Twelve individually
adjustable working positions are
possible.
Additionally, the cutting bar can be set to
a defined transport position.
Mounting the Gearbox
2
3
277BA007 KN
1
1
4
277BA027 KN
3
5
Adjusting the Cutter Bar
277BA016 KN
