NOTICE
The plug may come out of the drive tube when
you pull off the cap. Push it back into the shaft as
far as it will go.
6.1
Mounting the gearbox
A
402BA002 KN
► Apply a mark to the shaft at distance (A) of
50 mm (2 in.)
0000097202_001
1
2
► Push the gearbox (1) onto the shaft (2) as far
as stop – turn the gearbox back and forth until
the square end of the shaft engages
The gearbox is correctly positioned when the end
of its housing reaches or covers the mark
(arrow).
0000097203_001
1
3
3
► Insert the clamp screws (3) as far as it will go
1
0000097204_001
► Line up the gearbox (1) so that the chain
sprocket cover is exactly vertical and the lug
(arrow) on the end of the drive tube faces up
► Tighten down the clamp screws (3) in the fol‐
lowing sequence:
–
tighten the left screw moderately
–
tighten the right screw moderately
–
tighten down the left screw firmly
–
tighten down the right screw firmly
7
Mounting the KombiTool
1
002BA326 KN
2
► Push the lug (1) on the drive tube into the
slot (2) in the coupling sleeve as far as stop.
3
002BA327 KN
4
When correctly installed, the red line (3) (arrow
point) must be flush with the end of the coupling
sleeve.
► Tighten down the star knob (4) firmly.
7.1
Removing the KombiTool
► Reverse the above sequence to remove the
drive tube.
English
7 Mounting the KombiTool
10
0458-473-0121-E
