4.4.3
Flush-cutting thick branches
3
4
A
390BA024 KN
If the branch diameter is more than 10 cm (4 in),
first
► perform the undercut (3) and then cross-cut at
a distance of about 20 cm/8 in (A) from the
final cut. Then carry out the flush-cut (4), start‐
ing with a relieving cut and finishing with a
cross-cut
4.4.4
Cutting above obstacles
402BA013 KN
The machine's long reach makes it possible to
prune branches that are overhanging obstacles,
such as rivers or lakes. The tool angle in this
case depends on the position of the branch.
4.4.5
Cutting from a lift bucket
402BA032 KN
The machine's long reach enables cutting to be
performed next to the trunk without the risk of the
lift bucket damaging other branches. The tool
angle in this case depends on the position of the
branch.
English
4 Using the Unit
8
0458-473-0121-E
