8
Cutting Attachment
A cutting attachment consists of the saw chain,
guide bar and chain sprocket.
The cutting attachment that comes standard is
designed to exactly match the pole pruner.
001BA248 KN
1
2
3
a
–
The pitch (t) of the saw chain (1), chain
sprocket and the nose sprocket of the Rollo‐
matic guide bar must match.
–
The drive link gauge (2) of the saw chain (1)
must match the groove width of the guide
bar (3).
If non-matching components are used, the cut‐
ting attachment may be damaged beyond repair
after a short period of operation.
8.1
Chain Scabbard
001BA244 KN
The scope of supply includes a bar scabbard that
matches the cutting attachment.
If guide bars of different lengths are mounted to
the pole pruner, always use a chain scabbard of
the correct length which covers the complete
guide bar.
The length of the matching guide bars is marked
on the side of the chain scabbard.
9
Mounting the Bar and
Chain
9.1
Removing the chain sprocket
cover
0000003452_002
► Unscrew the nut and remove the cover
2
1
0000097194_001
► Turn the screw (1) counterclockwise until the
tensioner slide (2) butts against the left end of
the housing slot, then back it off 5 full turns
8 Cutting Attachment
English
0458-473-0121-E
11
