6.1.4
Fitting the Throttle Cable
NOTICE
Do not kink the throttle cable or lay it in tight radii
– make sure the throttle trigger moves freely.
15
15
15
14
14
0000-GXX-0512-A1
► Position the clamp (15) and handle sup‐
port (14) against the drive tube.
► Close the throttle cable retainer (15). The
retainer (15) snaps into place.
6.1.5
Adjusting the Throttle Cable
► Check adjustment of throttle cable – see chap‐
ter on "Adjusting the Throttle Cable".
6.1.6
Swiveling the Handlebar
Transport position
3
7
90°
0000-GXX-0513-A1
► Loosen the wing screw (3) and unscrew it until
the handlebar (7) can be rotated.
► Rotate the handlebar 90° counterclockwise
and then swing the handles down.
► Tighten down the wing screw (3) firmly.
Working position
► Reverse the sequence described above to
swing the handles up and turn the handlebar
clockwise.
7
Adjusting the Throttle
Cable
It may be necessary to correct the adjustment of
the throttle cable after assembling the machine
or after a prolonged period of operation.
Adjust the throttle cable only when the unit is
completely and properly assembled.
English
7 Adjusting the Throttle Cable
10
0458-436-0121-B