MS 193 C
English
19
Mounting the guide bar
N
Turn the screw (7)
counterclockwise until the tensioner
slide (8) butts against the left end of
the housing slot.
N
Fit the guide bar over the stud (9)
and engage the peg of the tensioner
slide in the hole (10).
Fitting the chain
WARNING
Wear work gloves to protect your hands
from the sharp cutters.
N
Fit chain around the sprocket (11)
and over the guide bar – the cutting
edges on top of the bar must point to
the bar nose.
N
Turn the tensioning screw (7)
clockwise until there is very little
chain sag on the underside of the
bar – and the drive link tangs are
engaged in the bar groove.
N
Refit the chain sprocket cover –
the pivot pin on the hand guard must
engage the sleeve – and then screw
the nut onto the stud fingertight.
N
Go to chapter on "Tensioning the
Saw Chain"
142BA059 KN
7
8
142BA060 KN
10
9
11
142BA061 KN
7
142BA062 KN
151BA003 KN
