MS 240
English
24
Holding the saw
There are two ways of holding the saw
when starting.
On the ground
N
Place your saw on the ground.
Make sure you have a firm footing –
check that the chain is not touching
any object or the ground.
N
Hold the saw firmly on the ground
with your left hand on the front
handle – your thumb should be
under the handle.
N
Put your right foot into the rear
handle and press down.
Between knees or thighs
N
Hold the rear handle tightly between
your legs, just above the knees.
N
Hold the front handle firmly with
your left hand – your thumb should
be under the handle.
Cranking
N
Pull the starter grip slowly with your
right hand until you feel it engage –
and then give it a brisk strong pull
and push down the front handle at
the same time. Do not pull out the
starter rope to full length –
it might
otherwise break
. Do not let the
starter grip snap back. Guide it
slowly back into the housing so that
the starter rope can rewind properly.
Machines without additional manual fuel
pump: If the engine is new or after a long
out-of-service period, it may be
necessary to pull the starter rope several
times to prime the fuel system.
143BA018 KN
143BA019 KN
143BA020 KN
Summary of Contents for MS 240
