25
MS 271 C, MS 291 C
Installing
– Clean the pivot pins and
disassembled parts,
– Lubricate the pivot pins,
:
Push the strap (1), outside
radius (arrow) facing up, onto the
pins (2) and (3).
:
Slip the spacer washer (1) onto
the pin (2).
:
Hold the brake lever (2) so that
the brake spring attachment
point (arrow) is at the top.
2710RA035 TG
1
2
3
2710RA036 TG
1
2
5902RA048 TG
1
2
:
Push the brake lever (2) into the
recess in the hand guard (1) and
line up the holes.
:
Fit the brake cable (1) in the
hole (arrow).
:
Push the hand guard (1) with
brake lever (2) over the machine
until they are positioned against
the pivot pins (arrows).
5902RA049 TG
1
off
2710RA037 TG
1
2
:
Lift the bearing boss of the hand
guard (1) and the brake lever (2)
a little and position them over the
pivot pins (arrows).
:
Turn the cam lever (1) to one side
until the cam of the hand
guard (arrow) slips passed it.
– Push the hand guard bearing
boss and the brake lever on to
the pivot pins.
:
Push the brake cable nipple (1)
into its seat (arrow).
off
2710RA038 TG
2
1
off
2710RA039 TG
1
2710RA040 TG
1
