50
MS 271 C, MS 291 C
7.7.2
Removing and Installing
– Remove the shroud,
b
6.4
– Pull the boot off the spark plug.
– Remove the fan housing,
b
8.2
– Remove the choke rod,
b
10.3.3
:
Lift the air guide shroud (1) a little
and pull the ignition lead (2) out
of the guides (arrows)
– take care not to distort the air
guide shroud.
:
Pull the short circuit wire (1) out
of the guide (arrow) and take it
away.
:
Take out the screw and remove
the ground wire (2).
2710RA132 TG
1
2
2710RA145 TG
2
1
:
Pull the wiring harness (1) out of
the guide (arrow).
– Remove the switch shaft,
:
Pull the short circuit wire (1) out
from behind the tab (arrow).
:
Pull the ring terminal (1) off the
peg (arrow).
:
Remove the switch shaft (2).
– Remove the filter base,
b
12.3
2710RA146 TG
1
2710RA161 TG
1
2710RA326 TG
1
2
– Remove the carburetor,
b
12.5
– Remove the carburetor carrier,
:
Push the rubber grommet (1) out
of the engine housing (2).
:
Pull out the wiring harness.
Installing
The protective tube (1) must butt
against the rubber grommet.
:
If necessary, push the wiring
harness in the direction of the
grommet until the protective
tube (1) butts against the
grommet (2).
2710RA327 TG
1
2
2710RA328 TG
1
2
