66
MS 271 C, MS 291 C
Installing
– Press the tank housing down a
little and hold it there.
:
Push the AV spring , bearing
plug (1) first, between the engine
housing and tank housing.
:
Push the bearing plug (1)
through the opening.
:
Push the bearing plug (2) into its
seat (arrow).
:
Push the tank housing (2)
upwards and hold it there.
:
Insert and tighten down the
screws (1) firmly.
– Reassemble all other parts in the
reverse sequence.
2710RA171 TG
2
1
2
2710RA172 TG
1
1
9.3
AV Spring on Handlebar
The AV spring is located between
the handle frame and cylinder.
– Remove the shroud,
b
6.4
– Remove the air filter,
b
12.1
:
Push the air guide shroud (1) in
direction of rear handle.
:
Take out the screw (2).
– Remove the handlebar,
b
9.5
:
Unscrew the bearing plug (1) and
disconnect the retainer (arrow).
:
Unscrew the spring (2) and pull
the retainer (arrow) out of the
handlebar.
2710RA173 TG
1
2
5902RA241 TG
1
2
Installing
:
Push the retainer (1), small
nipple first, through the hole in
the handlebar (2).
:
Screw the spring (3) onto the peg
as far as stop.
:
Attach the retainer (arrow) to the
bearing plug (1).
:
Screw the bearing plug (1) into
the spring as far as stop.
– Install the handlebar,
b
9.5
5902RA242 TG
3
1
2
5902RA243 TG
1
