MSA 160 T
English
14
Fitting the guide bar
N
Position the guide bar over the
bolts (1) – the cutting edges of the
saw chain must point to the right
N
Position the locating hole (2) over
the peg of the tensioner slide –
simultaneously place the saw chain
over the sprocket wheel (3)
N
Turn screw (3) to the right until there
is very little chain sag on the
underside of the bar – and the drive
link tangs engage in the bar groove
N
Refit the chain sprocket cover and
then screw on the nut by hand until
it is finger-tight
N
Go to chapter "Tensioning the
Chain"
For retensioning during operation:
N
Remove the battery from the
machine
N
Loosen nut
N
Raise the guide bar at the nose
N
Use the screwdriver to turn the
screw (1) to the right until the saw
chain rests against the underside of
the guide bar
N
Continue raising the guide bar
further and tighten the nut securely
N
Next step: Continue with "Checking
Chain Tension"
A new saw chain must be retensioned
more frequently than one that has been
in use already for an extended period!
N
Check chain tension frequently –
see "Operating Instructions"
3
1
1
2
9923BA010 KN
3
9923BA01
1 KN
9923BA012 KN
Tensioning the Chain
1
9923BA013 KN
Summary of Contents for MSA 160 T
