FS 460 C-M, FS 460 C-M L
English
14
Using the Circular Saw Blade
Circular saw blades are suitable for
thinning brush and cutting small trees up
to a diameter of 7 cm (2 3/4 in.). Do not
attempt to cut trees with larger
diameters, since the blade may catch or
jerk the trimmer / brushcutter forward.
This may cause damage to the blade or
loss of control of the power tool and
result in serious injury. Use a chain saw
for such work.
When a clearing saw with a circular saw
blade is used to cut down small trees,
STIHL recommends that the standard
deflector be removed and replaced by
the special limit stop deflector (see
chapter on "Mounting the Deflector").
This limit stop helps to keep the unit
positioned against the tree during the
cutting process. Inexperienced users
should place the left side of the stop
against the tree trunk before beginning
to cut. This will keep the clearing saw
against the tree during the cutting
operation and will reduce the risk of loss
of control and possible kickout
(described above and briefly again
below).
Before starting the cut, accelerate the
engine up to full throttle. Perform cut
with uniform pressure. STIHL
recommends that the circular saw blade
be applied to the right of the tree, using
the non-shaded area of the blade, as
shown in the illustration above.
When felling small trees, maintain a
distance of at least two tree lengths from
the nearest coworker.
Warning!
When cutting young saplings or other
woody materials up to 2 cm (3/4 in.) in
diameter, use the left side of the blade
to avoid "kickout" situations (see section
on "Risk of kickout (blade thrust) with all
rigid cutting blades"). Do not attempt to
cut woody material with a larger diame-
ter, since the blade may catch or jerk the
power tool forward. This may cause
damage to the blade or power tool or
loss of control of the power tool, result-
ing in personal injury. Use a circular saw
blade for such work.
Warning!
Inspect the brush knife at regular short
intervals for signs of damage. Do not
continue working with a damaged brush
knife. Resharpen the brush knife regu-
larly (when it has dulled noticeably).
002BA067 KN
Warning!
To reduce the risk that the blade will
crack and / or break, avoid all contact
with stones, rocks or the ground.
Sharpen blades in a timely manner as
specified – dull teeth may cause the
blade to crack or shatter.
002BA214 ST
Warning!
The risk of kickout is highest when cut-
ting in the darker shaded area. To
reduce the risk of kickout and resulting
injury, do not use this area of the circular
saw blade for cutting trees or shrubs.
Special techniques using the lighter
shaded areas of the blade to cut shrubs
and trees should only be used by expe-
rienced operators with specialized
training in the use and control of the
clearing saw.
Warning!
In order to reduce the risk of injury from
thrown objects or operator contact with
the blade or head, be sure to remount
the standard deflector when no longer
using a circular saw blade.
002BA068 KN
Summary of Contents for Operating instructions
Page 2: ...Instruction Manual 1 47 Manual de instrucciones 49 99 ...
Page 50: ...FS 460 C M FS 460 C M L English 48 ...
Page 102: ...FS 460 C M FS 460 C M L español EE UU 100 ...
Page 103: ......
