Stihl RG-KM, Instruction Manual

6.2.2

Removing the KombiTool

► Fit the transport guard.

► Loosen the wing screw on the KombiTool.

► Pull the drive tube out of the KombiTool.

7

Checking the KombiTool

7.1

Checking the Blades

► Switch off the KombiMotor.

a

b

c

0000-GXX-8740-A0 

► Measure the following points on the blades:

–

Length a

–

Width b

–

Angle c

► Compare measurements,   15.2.

► If the minimum length is less than specified:

Offset the blades,   13.4.

► If the minimum width is less than specified:

Replace the blades,   13.3.

► If the filing angle is not correct: Sharpen the

blades,   13.5.

► If you have any queries: Contact a STIHL

servicing dealer for assistance.

8

Using the KombiTool

8.1

Holding and Controlling the

KombiTool

2

1

0000-GXX-7807-A0 

► Hook the KombiMotor’s carrying ring (2) to the

carrying system’s carabiner (1).

KombiMotor with loop handle.

0000-GXX-4644-A0

► Hold the KombiMotor with your right hand on

the control handle – wrap your thumb around

the control handle.

► Hold the KombiMotor with your left hand on

the loop handle – wrap your thumb around the

loop handle.

KombiMotor with bike handle

0000-GXX-7850-A0 

► Hold the KombiMotor with your right hand on

the control handle – wrap your thumb around

the control handle.

► Hold the KombiMotor with your the left hand

on the handle – wrap your thumb around the

handle.

8.2

Weeding and Mowing Grass

The cutting height is determined by the distance

of the blades from the ground.

0000-GXX-8737-A0 

► Swing the KombiTool back and forth in an arc.

► Walk slowly and steadily forwards.

9

After Finishing Work

9.1

After Finishing Work

► Switch off the KombiMotor.

7 Checking the KombiTool

English

0458-811-0121-C

7