► If the KombiTool is wet: Allow KombiTool to
dry.
► Clean the KombiTool.
► Fit the transport guard.
10 Transporting
10.1
Transporting the KombiTool
► Switching the KombiEngine Off.
► Fit the transport guard.
Carrying the KombiTool
► Carry the KombiTook with one hand on the
drive tube.
Transporting the KombiTool in a vehicle
► Secure the KombiTool to prevent turnover and
movement.
11 Storing
11.1
Storing the KombiTool
► Switch off the KombiMotor.
► Fit the transport guard.
► Check the following points when storing the
KombiTool:
–
KombiTool is out of the reach of children.
–
KombiTool is clean and dry.
12 Cleaning
12.1
Cleaning the KombiTool
► Switch off the KombiMotor.
► Allow gear housing to cool down.
► Clean the KombiTool with a damp cloth.
12.2
Cleaning the Blades
► Switch off the KombiMotor.
► Spray the blades with STIHL resin solvent.
► Switch on the KombiMotor for 5 seconds.
The blades run. STIHL resin solvent is distrib‐
uted evenly.
13 Maintenance
13.1
Maintenance Intervals
The maintenance intervals are dependent on the
environmental and operating conditions. STIHL
recommends the following maintenance inter‐
vals:
After every 25 hours of operation
► Lubricate the gearbox.
13.2
Lubricating the Gearbox
► Switch off the KombiMotor.
2
1
0000-GXX-8739-A0
► Remove the screw plug (2).
► If no grease can be seen on the end of the
screw plug (2):
► Screw the tube (1) of STIHL gear grease
into the filler hole.
► Pump 10 g of STIHL gear grease into the
gear housing.
► Unscrew the tube (1) of STIHL gear grease.
► Refit and tighten down the screw plug (2)
firmly.
► Run the KombiMotor for 1 minute.
STIHL gear grease is distributed evenly.
13.3
Removing and Attaching the
Blade
13.3.1
Removing the Blades
WARNING
■ The cutting edges of the blades are sharp.
There is a risk of cut injuries.
► Wear work gloves made of durable mate‐
rial.
► Switch off the KombiMotor.
2
1
6
4
3
5
0000-GXX-8733-A0
► Remove screw (1) clockwise.
► Remove the rider plate (2).
► Remove screws (3) counterclockwise.
► Remove the blade (4).
► Remove screws (5) counterclockwise.
► Remove the blade (6).
English
10 Transporting
8
0458-811-0121-C
