25
TS 500i
4.
Cast arm with guard
4.1
Water system
4.1.1
Nozzles
:
Take out banjo screws (arrow) on
both sides – the square nuts
inside the guard drop down.
:
Take out and examine the water
hose (1), replace if necessary
– Check banjo screws, O-rings and
seal, replace if necessary
:
Remove screw (1)
:
Guide the adjusting lever (2) over
the lift-off lugs (arrow) with a
gentle turning movement and
remove it.
1
370RA003 TG
370RA004 TG
2
1
Installation
When fitting the adjusting lever, it is
simply pushed into place until it
engages.
– Insert and tighten the screw
:
Fit the connector (1) with water
hose and align it at a right angle
to the adjusting lever (2).
– Coat O-ring with STIHL press
fluid,
:
Insert banjo screw (3)
– Do not damage O-ring
Opposite side
:
Push gasket (1) onto banjo
screw (2)
– Coat O-ring with STIHL press
fluid,
:
Insert banjo screw (2)
– Do not damage gasket or
O-ring
1307RA364 TG
2
3
1
1307RA000 TG
1
2
:
Fit the square nuts (1) in the
guides (arrows) inside the guard
on both sides and hold it.
:
Hold the square nuts (1) in place
and screw in and tighten banjo
screws on both sides
4.1.2
Water hose
:
Apply a screwdriver to the hose
clip (arrow) and turn slightly to
open the clip.
:
Remove water hose (1)
370RA006 TG
1
370RA007 TG
1
Summary of Contents for TS 500i
Page 1: ...STIH STIHL TS 500i 2012 02...
Page 116: ...115 TS 500i...
Page 117: ...116 TS 500i...
Page 118: ...englisch english 0455 753 0123 VA0 B12 Printed in Germany...
