47
TS 500i
:
Take out the screws (arrows)
:
Remove the shroud (1)
:
Check bushing (1), pull out of
mount (arrow) if necessary and
replace
:
Check rubber buffer (1), pull out
of mount (arrow) if necessary and
replace
:
Check the piece of hose (2),
remove and replace if necessary
– Examine the throttle trigger and
trigger interlock, replace if
necessary,
1307RA080 TG
1
1307RA081 TG
1
1307RA082 TG
1
2
– Check short circuit wire, control
panel and switch, replace if
necessary,
Installation
:
Push rubber buffer (1) with lug
into the hole (arrow) as far as it
will go
Piece of hose (2) must
be pushed on
– Piece of hose (2) acts as hold
down for the injection pump.
:
Lift plug (1) out of opening
:
Guide the shroud (2) over the
injection pump and position so
that the lugs (arrows) engage in
the mounts – Do not pinch the
plug (1)
1307RA083 TG
1
2
1307RA084 TG
2
1
:
Insert and tighten the screws
(arrows)
:
Hook the throttle cable (1) into
the throttle trigger (2)
:
Move throttle cable (2) towards
full-throttle until the nipple of the
throttle cable engages in the
throttle trigger
:
Press the grommet (1) into the
mount (arrow) until it is fully home
1307RA085 TG
1307RA086 TG
1
2
1307RA087 TG
1
Summary of Contents for TS 500i
Page 1: ...STIH STIHL TS 500i 2012 02...
Page 116: ...115 TS 500i...
Page 117: ...116 TS 500i...
Page 118: ...englisch english 0455 753 0123 VA0 B12 Printed in Germany...
